Table of Contents
Advertisement
Handling Cylinders
•
If it becomes necessary to move cylinders, do so with a suitable hand truck
after ensuring that the container cap is secured and the cylinder properly
fastened to the hand truck.
•
Use only gas-pressure regulators, tubing, and hose connectors approved by an
appropriate regulatory agency.
•
Arrange gas hoses where they will not be damaged or stepped on, and where
objects will not be dropped on them.
•
Do not refill gas cylinders.
•
Check the condition of pipes, hoses, and connectors regularly. Perform gas
leak tests at all joints and seals of the gas system regularly, using an approved
gas leak detection solution.
•
When the equipment is turned off, close all gas cylinder valves tightly at the
cylinder. Bleed the remainder of the line before turning the exhaust vent off.
Hazardous Chemicals Warnings
Before using any chemicals or solvents with the instrument, the customer should
be thoroughly familiar with all hazards and safety handling practices. Observe the
manufacturer's recommendations for use, storage and disposal. These
recommendations are normally supplied in the material safety data sheets (MSDS)
supplied with the solvents.
Some chemicals used with this instrument may be hazardous or may
!
become hazardous after completing an analysis. The responsible body
(e.g. Lab Manager) must take the necessary precautions to ensure that the
Warning
surrounding workplace and the instrument operators are not exposed to
hazardous levels of toxic substances (chemical or biological) as defined
in the applicable Material Safety Data Sheets (MSDS) or OSHA, ACGIH,
or COSHH documents. Venting for fumes and disposal of waste must be
in accordance with all national, state, and local health and safety
regulations and laws.
Safe Handling of Gas Cylinders
45
Advertisement
Table of Contents
Troubleshooting
