Removing The Nebulizer/End Cap - PerkinElmer AVIO 500 Customer Hardware And Service Manual

Maintenance
258

Removing the Nebulizer/End Cap

To remove the nebulizer/end cap assembly:
1. Turn off the plasma if it is on.
If the plasma has been on, allow one minute for the Quick-Change
!
Adjustable Torch Module to cool and an additional two minutes for the
torch to cool before handling.
Warning
Avertissement: If the plasma has been on, allow one minute for the
Quick-Change Adjustable Torch Module to cool and an additional two
minutes for the torch to cool before handling.
2. Remove the scott spray chamber (see Removing the Scott Spray Chamber on
page 222).
3. Twist off the nebulizer end cap and end cap ring, together, off the spray
chamber.