Replacing The Plasma Induction Plates - PerkinElmer AVIO 500 Customer Hardware And Service Manual

Maintenance
230

Replacing the Plasma Induction Plates

Plasma Induction Plates
Regularly inspect the plasma induction plates. They should not show any signs of
deforming or pitting.
If your lab has high humidity, check the plasma induction plates to make sure they
are dry. Use a soft dry cloth to dry the plasma induction plates if necessary. Contact
your PerkinElmer Service Representative to replace and adjust the plasma
induction plates.
Replacing the Plasma Induction Plates
The plasma induction plates may need to be replaced occasionally as a result of
overheating, pitting, or arcing. Contact your Perkin Elmer Service Representative
to replace the plasma induction plates.
Table 5-3.
Part No.
09992731
N0810346
N0810128
N0810606
N0810607
N0791180
N0791181
N0791182
N0791183
Replacement Parts: Torch Module
Description
Axial Window
Radial Purge Window
Torch Body Assembly
Quick Change Torch Module-Scott Spray Chamber
Quick Change Torch Module-Cyclonic Spray Chamber
Alumina Injector 0.80mm
Alumina Injector 1.2 mm
Alumina Injector Straight 1.2 mm
Alumina Injector, 2.0 mm ID, 150 mm LG (standard injector)