Replacing The Torch On The Mount - PerkinElmer AVIO 500 Customer Hardware And Service Manual

Maintenance
220
Item
3 Knurled Nut (Part No. N0776027)
4 Washer (Part No. N0776028)
5* O-Ring (Part No. 09902223) After
removing the torch the lower O-ring
may move out of position. Make
sure to push the lower O-ring all the
way down on the ledge it rests on
before you return the torch
glassware. If the O-ring is not in the
proper location leaks will occur.
*See the note below.
If the torch glass does break, discard the broken torch and replace the torch
Note
glass. Remove the knurled nut, sleeve and washers and make sure that you
remove all glass fragments.
2. Slide in the injector assembly straight into the bottom of the torch cassette then
rotate to the right to lock in place.
3. Tighten the knurled nut.

Replacing the Torch on the Mount

The following steps describe how to replace the torch in the mount. Refer to the
next two figures.
Caution
Only use PerkinElmer Flat Plate Torch Glassware
glassware will damage the torch.
Utiliser uniquement PerkinElmer Plate Flat Torch Glassware
Attention
L'utilisation de tout autre verrerie endommager la torche.
Description Item Description
8 Cassette (Part No. N0810214)
9 Stripe on Torch
10 Index Mark on Torch Holder
TM
. Using any other
TM
.