After Operation; After Operation Safety; Pushing The Machine By Hand - Toro 74676 Operator's Manual

Table of Contents

Advertisement

After Operation

After Operation Safety

General Safety
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
Shut off the fuel before storing or transporting the
machine.
Disengage the drive to the attachment whenever
you are transporting or not using the machine.
Allow the engine to cool before storing the machine
in any enclosure.
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Do not tow the machine, because towing may
damage it.
This machine has an electric-brake mechanism, and
to push the machine, the ignition key must be in the
position. The battery needs to be charged and
RUN
functioning to disengage the electric brake.
Pushing the Machine
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Locate the bypass levers on the frame on both
sides of the engine.
4.
Move the bypass levers forward through the key
hole and down to lock them in place
Note:
Do this for each lever.
5.
Turn the ignition key on and disengage the
parking brake.
Note:
Do not start the machine.
1. Bypass-lever locations
2. Lever position for
operating the machine
6.
When finished, ensure that the key has been
returned to the
the battery charge.
Note:
may still be engaged. You can release the electric
brake manually if necessary; refer to
Electric Brake (page
Operating the Machine
Move the bypass levers rearward through the keyhole
and down to lock them in place as shown in
Note:
(Figure
31).
28
Figure 31
3. Lever position for pushing
position to avoid draining
STOP
If the machine fails to move, the electric brake
43).
Do this for each lever.
g017303
the machine
Releasing the
Figure
31.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Timecutter sw 5000Timecutter sw 420074680

Table of Contents