Table of Contents
Advertisement
7. Check where the control lever is relative to notch in
console (Fig. 55). It should be centered allowing lever
to pivot outward to the neutral lock position.
3
Figure 55
1. Neutral locked position
2. Control lever
8. If adjustment is needed, loosen the nut and jam nut
against the yoke (Fig. 56).
9. Apply slight rearward pressure on the motion control
lever, turn the head of the adjustment bolt in the
appropriate direction until the control lever is centered
in neutral lock position (Fig. 55).
Note: Keeping rearward pressure on the lever will keep
the pin at the end of the slot and allow the adjustment bolt
to move the lever to the appropriate position.
10. Tighten the nut and jam nut (Fig. 56).
11. Repeat on the opposite side of the machine.
2
1
m–6282
3. Neutral position
43
9
2
6
7
3
11
10
4
Figure 56
1. Clevis pin in slot
2. Nut against yoke
3. Adjustment bolt
4. Pump rod
5. Double nuts
6. Jam Nut
Setting the Hydraulic Pump
Neutral
Note: Adjust handle neutral first. That has to be correct
before the following adjustment can be made.
Danger
Mechanical or hydraulic jacks may fail to support
machine and cause a serious injury.
Use jack stand when supporting machine.
Do not use hydraulic jacks.
Warning
Engine must be running so motion control
adjustment can be performed. Contact with
moving parts or hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other body
parts away from rotating parts, muffler and other
hot surfaces.
This adjustment must be made with drive wheels turning.
1
8
11
10
5
M–6278
7. Spring
8. Pivot shaft
9. Yoke
10. Locknut
11. Ball joint
Advertisement
Table of Contents
