Pan And Tilt Encoder; Configuring Pan And Tilt Encoder Wheel - GLP SCAN OPERATOR FX II User Manual

4.14

Pan and Tilt Encoder

You can assign the Pan/Tilt Encoder wheels for each Fixture to one of the 16 DMX of
channels in each case. They serve as additional input mode for Pan and Tilt values
beside the appropriate DMX faders. In addition the effect generator also falls back to the
channels adjusted here, if Pan/Tilt effects are produced.
You can make change Pan and Tilt values of different DMX fixtures, even if the DMX
channel reservation is different.
So Pan/Tilt can be on the channels 1/2 on set 1 and on channel 5/6 on set 2. By using
the Pan/Tilt Encoder wheels you can access the Pan/Tilt of both devices.
After a deletion of the entire memory, channels 1 and 2 are assigned to the Pan/Tilt
wheels for each Fixture.

4.14.1 Configuring Pan and Tilt Encoder wheel

In order to assign to the Pan and Tilt Encoders to a channel, you proceed as follows:
1. Activate the Setup mode (SETUP key).
2. Now select "Pan" or "Tilt" in the menu of the Setup mode
3. Select desired fixtures with appropriate fixture keys. Several fixtures can be
selected at the same time for configuration.
4. Use the scenes keys, in order to assign a pan and/or Tilt channel to the
selected Fixtures of the current channel. In the display the respective channel
is then confirmed with "Channel pan XY" or "Channel Tilt XY".
5. If necessary you press the PAGE key, in order to be able to change the
further 8 DMX channels (channels 9-16).
6. Repeat the steps 2 to 5, in order to configure further fixtures.
Important:
The changes are not automatically durably stored but they are directly active.
Therefore it is necessary that you confirm the changes for durable storing once
with the RECORD or the SETUP key.
39/57