Reference
Finishing Touches
Sanding the Model
Use sandpaper to remove small bits of material without changing the part's
dimensional tolerances. Use 320 grit sandpaper to give the part a smooth surface.
Sand manually to give the model a smooth final finish.
l
Polishing With D-Limolene
Use a melting chemical such as D-Limolene, to further smooth the part surface.
1)
Use a cotton swab or foam swab in the finger of a cotton glove.
2)
Dip the swab into the D-Limolene.
3)
Remove excess chemical by dabbing on paper towel.
4)
Apply chemical in a smooth, circular motion.
5)
Use a dry swab to soak up excess chemical and help smooth model.
Finishing Wax With Patch-Eze
Gaps in the wax model must be filled before the model can be shelled. Stratasys
recommends using Patch-Eze red patch wax to fill small gaps.
Patch-Eze is tacky and should not be used as a general filler. This is
because casters rinse the model with a citrus based solvent. This
solvent might dissolve the Patch-Eze.
Patch-Eze can be softened further by dipping it into water.
1)
Put some Patch-Eze on a small spatula.
2)
Dip the spatula into warm water to allow the Patch-Eze to soften.
3)
Apply the Patch-Eze to the model.
4)
Smooth and press the Patch-Eze into place.
Chemical Finishing and Polishing
®
and Master Extra Soft Utility Red Wax
10MAY01
A-13
Applications Manual