Stratasys FDM 2000 Manual page 13

F2/3/8000-ii
FDM 2000/3000/8000 Manual History
Manual Release
1.0
2.0
Notice
The information in this document is subject to change without notice.
STRATASYS, INC. MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS MATE-
RIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABIL-
ITY AND FITNESS FOR A PARTICULAR PURPOSE. Stratasys, Inc. shall not be liable for errors
contained herein or for incidental or consequential damages in connection with the furnishing,
performance, or use of this material.
This document is protected by copyright. All rights reserved. Its use, disclosure, and possession are
restricted by an agreement with Stratasys per software copyright. No part of this document may be
photocopied, reproduced or translated into another language without the prior written consent of
Stratasys, Inc. Printed in the USA.
FDM 1500, FDM 1600, FDM 1650, FDM 2000, FDM 3000, FDM 8000, 3D PLOTTER, FDM, Insight,
Models in Minutes, ProtoSlice, and QuickSlice are trademarks of Stratasys, Inc.
Unix is a registered trademark of AT&T Bell Laboratories.
© 2000 Stratasys, Incorporated
FDM 2000/3000/8000 Manual
Date
September 1999
May 2001
Stratasys, Inc.
14950 Martin Drive
Eden Prairie, MN 55344 USA
phone (952) 937-3000
fax (952) 937-0070
Web site www.stratasys.com
10 MAY 01
Contents