Stratasys FDM 2000 Manual page 40

F2/3/8000-34
Hold down the rapid move button while pressing any of the directional
move buttons for faster head positioning.
3) Push the Z-axis button to activate positioning in the Z direction. The two
Z-move button lights will turn on.
4) Press the top move button to raise the foam into position. The model tip
should be imbedded into the foam surface.
5) Press the pause button to begin modeling.
If the material on the mounted spool runs out of material before the
model is completed, the FDM will pause. Mount and load a new spool
of material and then press the Pause button to resume building the
model.
Aborting a Model
To abort a model in process:
1) Close the FDM status window.
FDM 2000/3000/8000 Manual
Usage—Modeling Operations
10MAY01
Procedures