Stratasys FDM 2000 Manual page 129

Reference
Keypad Display Messages
Key pad messages display information about the FDM.
PD Time Fault
The PD Time Fault message appears when a PD time exceeds five con-
tinuous seconds.
XY Time Fault
The XY Time Fault message appears when there is uninterrupted head
movement for five minutes.
Torque Limit
The Torque Limit message appears when the active torque on the
motor exceeds the preset limit.
Filament Out
This message appears if there is no filament loaded in the FDM. It
also appears if neither filament sensor detects filament for 30
seconds while there is XY head movement.
Load Time Fault
This message appears if the operator tries to load filament for 2
consecutive minutes.
been shut off.
NV Memory Error
This message indicates one of the values stored in the keypad is
outside the acceptable range. The user should check the keypad
values.
Low Temp Set
This message indicates that the support watlow has lowered to it's "safe
temperature.
Pressing "Enter" clears any alarm messages.
The "% FLOW" setting has a direct relationship effect on the gain
numbers during modeling.
®
It indicates the feed to the liquefiers has
10MAY01
F2/3/8000-49