Stratasys FDM 2000 Manual page 144

M1-4
P301 - Plastic Material (Polyamide)
FDM System
Parameters
Speed inches/sec
(maximum)
(recommended)
Road Height
(maximum)
(minimum)
(recommended)
Road Width
(maximum)
(minimum)
Liquefier Temp °C
(maximum)
(minimum)
(recommended)
Envelope Temp °C
(maximum)
(minimum)
(recommended)
Room Temp °F
(maximum)
Tensile Strength (psi):
Flexural Strength (psi):
Tensile Modulus (psi):
Flexural Modulus (psi):
Notched Impact (ft*lb/in):
* Material specifications are based on ASTM tests.
Materials Appendix
Materials Plastic
FDM 1500 and 1600
FDM Tip Inner Diameter
0.016"
0.500
0.500
0.014"
0.010"
0.010"
0.050"
0.016"
155
130
See Spool
40
10
40
82
I
t is recommended to use the parameter values indicated in
bold for perimeter roads. The values in this table may also be
applied to fill and support roads if desired.
The properties of P301 require a minimum of 1-2 minutes
between deposited layers to solidify. The maximum wait
time allowed by the hardware controller is 60 seconds. For
small geometry, multiple parts can be modeled to achieve a 2
minute wait between z levels.
Material
Specifications*
1,765
2,113
80,000
60,000
0.24
10MAY01
0.025"
0.700
0.500
0.020"
0.010"
0.010"
0.090"
0.030"
155
130
See Spool
40
10
40
82
Unnotched Impact (ft*lb/in): 1.46
Elongation (%):
Hardness (Shore D):
Softening Point (R&B) (F):
Specific Gravity (GMS/CM
Reference
3.48
70D
----
3
): 1.10