Stratasys FDM 2000 Manual page 115

N-12
T10 Tip Modeling Techniques
•
For best results, run two or three parts at a time.
•
Be careful not to damage the end of the tip.
•
Make sure to use dry ABS material only.
•
Do not use the Sparse fill feature on the part. Use the T12 tip if you need to
use the Sparse fill feature with a .007-inch slice.
•
Use the auto-shutoff feature if the machine will be idle for an extended time
after the part is completed.
Notes
10MAY01
Reference
®