Delta Electronics ASDA-A2 Series User Manual page 502

Call 1(800)985-6929 for Sales
Chapter 10 Troubleshooting
: Password error
Potential Cause
The parameter is
password protected
when using
CANopen
communication to
access the
parameter.
Motion Control Fault Messages
: CANopen data initial error
Potential Cause
An error occurs
when loading data
from EE-PROM.
~
Potential Cause
In PR mode, error
occurs when using
PR command
TYPE=8 (write
specified parameter)
Revision January 2011
Call 1(800)985-6929 for Sales
deltaacdrives.com
Checking Method
Check if the password for the specified
object is invalid when accessing PDO
object.
Checking Method
1. Restart the servo drive to check if the
error can be cleared.
2. If the error cannot be cleared after
restarting the servo drive, it indicates
that the data in EE-PROM is damaged
and the users must do the following
actions:
a. If the users want to write default
setting values, set P2-08 to 30 first
and then 28 next, or use CANopen
"0x1011" object to restore
parameters from non-volatile
memory.
b. If the users want to write current
setting values, use CANopen
"0x1010" object to save
parameters in non-volatile
memory.
: Write parameter error
Checking Method
: Check if the parameter
setting value exceeds the limit of normal
range.
: Check if the parameter is
read only.
,
parameter is write-protected when Servo
On or the setting value is invalid.
deltaacdrives.com
NMT Maser send "Reset
node" command to its slave or
reset the fault by sending the
control word (0x6040) through
CAN communication (the value
of CANopen object 0x6040
should be reset)
1. Turn ARST (DI signal) ON to
clear the fault.
2. Use CANopen "0x1011"
object to restore default
parameters.
1. Turn ARST (DI signal) ON to
clear the fault.
2. Set P0-01 to 0.
: Check if the
Correct the PR command and
parameter setting value.
sales@deltaacdrives.com
Corrective Actions
Corrective Actions
Corrective Actions
10-19
sales@deltaacdrives.com