Table of Contents
Advertisement
Call 1(800)985-6929 for Sales
Chapter 5 Trial Run and Tuning Procedure
Ensure that the external applied voltage to the drive is correct and matched to the
controller.
2. Inspection during operation (Control power is applied)
Ensure that the cables are not damaged, stressed excessively or loaded heavily. When
the motor is running, pay close attention on the connection of the cables and notice
that if they are damaged, frayed or over extended.
Check for abnormal vibrations and sounds during operation. If the servo motor is
vibrating or there are unusual noises while the motor is running, please contact the
dealer or manufacturer for assistance.
Ensure that all user-defined parameters are set correctly. Since the characteristics of
different machinery equipment are not the same, in order to avoid accident or cause
damage, do not adjust the parameter abnormally and ensure the parameter setting is
not an excessive value.
Ensure to reset some parameters when the servo drive is off (Please refer to Chapter 8).
Otherwise, it may result in malfunction.
If there is no contact sound or there be any unusual noises when the relay of the servo
drive is operating, please contact your distributor for assistance or contact with Delta.
Check for abnormal conditions of the power indicators and LED display. If there is any
abnormal condition of the power indicators and LED display, please contact your
distributor for assistance or contact with Delta.
5-2
Call 1(800)985-6929 for Sales
deltaacdrives.com
deltaacdrives.com
sales@deltaacdrives.com
Revision January 2011
sales@deltaacdrives.com
Advertisement
Table of Contents
