Delta Electronics ASDA-A2 Series User Manual page 224

Call 1(800)985-6929 for Sales
Chapter 7 Motion Control Functions
OPT:
Bit 7 Bit 6
CMD
0 0
1 0
0 1
1 1
※ When the TYPE is set to 1 ~ 3, it can accept DO signals, STP (Motor Stop), SNL(SCWL,
Reverse Software Limit), SPL(SCCWL, Forward Software Limit).
INS: Insertion command on PR.
OVLP: Overlap the next PR. This function is not available in speed mode. In position mode,
DLY becomes disabled.
CMD: The calculation method for Cmd_E (End of position command) is described in the notes
below:
Note 1: The end of position command is an absolute position command which is equal to
DATA directly.
Note 2: The end of the position command is an incremental position command which is
equal to the end of the position command (Cmd_E, monitor variable 40h) plus a
designated DATA.
Note 3: The end of the position command is a relative position command which is equal to
current feedback position (monitor variable 00h) plus a designated DATA.
Note 4: The end of the position command is a capture position command which is equal to
capture position (monitor variable 2Bh) plus a designated DATA.
8) Special Function: TYPE = 7. Jump to the dedicated PR.
Bit
31 ~ 28 27 ~ 24 23 ~ 20 19 ~ 16
DW0
DW1
OPT:
Bit 7
-
PR Number: Dedicated jump PR
Revision January 2011
Call 1(800)985-6929 for Sales
Bit 5 Bit 4
OVLP INS
Absolute position command: Cmd_E = DATA (Note 1)
Incremental position command: Cmd_E = Cmd_E + DATA
(Note 2)
- -
Relative position command: Cmd_E = Current feedback
position + DATA (Note 3)
Capture position command: Cmd_E = Capture position +
DATA (Note 4)
- - DLY
OPT
Bit 6 Bit 5
- -
deltaacdrives.com
OPT
Explanation
15 ~ 12
- FUNC_CODE
PR Number ( 0 ~ 63 )
Bit 4
INS
deltaacdrives.com
sales@deltaacdrives.com
11 ~ 8 7 ~ 4 3 ~ 0
OPT 7
sales@deltaacdrives.com
-
7-21