Table of Contents
Advertisement
Figure 3-16
NOTE
Port 1 Power Functions
NOTE
Operation
Port Power
Port Power
Port-specific power settings are made using this menu:
STIMULUS [MENU] {POWER MENU}
Power Menu & Equivalent GPIB Commands
The port power functions are valid only if
the
[SYSTEM] {MORE} {RF POWER CONFIG}
on page
3-30).
The first three softkeys control the power level from Port 1 (and also from
Port 2, if the ports are coupled).
, followed by a number, specifies a power level setting for
{PORT1 POWER}
Port 1, in dBm. If the ports are coupled, this setting applies also to Port 2.
and
{PORT1 SLOPE ON}
{PORT1 SLOPE OFF}
slope for Port 1.
{PORT1 SLOPE ON}
slope setting for Port 1, in dB/GHz. If the ports are coupled, this setting
applies also to Port 2.
During operation in the power slope mode, the power at the first frequency
of the sweep is the current port power level; slope is applied as frequency
increases. Power slope has no effect on CW measurements.
3-28 8510XF Network Analyzer Systems
{RF LEVEL / SYSTEM}
menu (see
"RF Power Configuration"
are used to enable and disable power
, followed by a number, specifies the power
is selected on
Advertisement
Table of Contents
