Unsupported Gpib Commands - Agilent Technologies 8510XF Operating And Service Manual

Unsupported GPIB Commands

The table below lists GPIB commands that are supported by the standard
8510C firmware, but are not supported by the 8510XF firmware.
Sending these commands to the 8510XF will not cause a problem; the
system will ignore them. However, if you use a test program that was
developed for other 8510C test sets, be aware that the commands listed
below will have no effect.
Table 7-3 GPIB Commands Not Supported by 8510XF
COMMAND
CONF
COUC
DEFA
DEFIRECV
DEFISOUR1
DEFISOUR2
DETENORB
DETEWIDB
DUTC
EDITMULS
FLATON
FLATOFF
FLAT?
LOCKA1
LOCKA2
LOCKNONE
LOCSFAST
LOCSNORM
FUNCTION
Constant frequency value
Couple channel 1 & 2 stimulus and
calibration sets
Multiple source default equation
Multiple source define receiver equation
Multiple source define RF source #1
Multiple source define LO source #2
Select the 10 KHz IF path and detectors
Select the 3 MHz IF bandwidth path and
detectors
Set the duty cycle of the internally generated
trigger
Edit multiple source equations
Enable flatness correction calibration.
Turn off flatness correction calibration.
Queries status of flatness correction
calibration.
Select a1 as phaselock input for current
parameter
Select a2 as phaselock input for current
parameter
Do not attempt receiver phaselock
Select fast system phaselock
Select normal system phaselock
8510XF Network Analyzer Systems 7-47
Menus & Commands
Unsupported GPIB Commands
ACTIVE FUNCTION?
YES
NO
NO
NO
NO
NO
NO
NO
YES
NO
NO
NO
NO
NO
NO
NO
NO
NO