Table of Contents
Advertisement
Connectors (Port 1)
Connectors (Port 2)
Installation
Millimeter-Wave Controller
RF OUTPUT
This 2.4 mm connector provides the left test head with
the RF signal that is used for frequencies up to 50 GHz.
MM DRIVE
This 2.4 mm connector provides the left test head with
the RF signal that is used for frequencies above 50 GHz
(this signal is multiplied within the test head).
LO OUTPUT
This 3.5 mm connector provides the left test head with
the LO signal that is used for all frequencies.
a1 RF INPUT
This 3.5 mm connector is installed only in systems that
include Option 005; it receives (from the left test head)
the "a1" RF input for frequencies below 2 GHz.
b1 RF INPUT
This 3.5 mm connector is installed only in systems that
include Option 005; it receives (from the left test head)
the "b1" RF input for frequencies below 2 GHz.
BIAS
This multi-pin connector provides power supply voltages
to the left test head.
TEST HEAD
INTERFACE
This multi-pin connector provides paths for various
signals between the controller and the left test head
(including 20 MHz IFs from mixers in the test head).
RF OUTPUT
This 2.4 mm connector provides the right test head with
the RF signal that is used for frequencies up to 50 GHz.
MM DRIVE
This 2.4 mm connector provides the right test head with
the RF signal that is used for frequencies above 50 GHz
(this signal is multiplied within the test head).
LO OUTPUT
This 3.5 mm connector provides the right test head with
the LO signal that is used for all frequencies.
a2 RF INPUT
This 3.5 mm connector is installed only in systems that
include Option 005; it receives (from the right test head)
the "a2" RF input for frequencies below 2 GHz.
b2 RF INPUT
This 3.5 mm connector is installed only in systems that
include Option 005; it receives (from the right test head)
the "b2" RF input for frequencies below 2 GHz.
BIAS
This multi-pin connector provides power supply voltages
to the right test head.
TEST HEAD
INTERFACE
This multi-pin connector provides paths for various
signals between the controller and the right test head
(including 20 MHz IFs from mixers in the test head).
2-24 8510XF Network Analyzer Systems
Advertisement
Table of Contents
