Table of Contents
Advertisement
Full 2-Port Isolation
Standards
Figure 3-15
Notes on the Standards
NOTE
These standards are used to measure forward and reverse isolation for full
2-port calibrations. When you perform a calibration of that type using a
1.0 mm calibration kit, you will see the following menu:
Full 2-Port Isolation Calibration Menu & Equivalent GPIB Commands
{FWD ISOL'N
Refer to "Isolation" under "Banded Standards" in
LOAD}
Table 3-1 on page
{REV ISOL'N
Refer to "Isolation" under "Banded Standards" in
LOAD}
Table 3-1 on page
To skip the isolation part of the calibration, select
3-12.
3-12.
{OMIT ISOLATION}
8510XF Network Analyzer Systems 3-27
Operation
Standard Types
.
Advertisement
Table of Contents
