Table of Contents
Advertisement
One-Path
Transmission
Standards
Figure 3-12
Notes on the Standards
NOTE
Operation
Standard Types
These standards are used to measure transmission and match for one-path
2-port calibrations. When you perform a calibration of that type using a
1.0 mm calibration kit, you will see the following menu:
One-Path Transmission Calibration Menu
& Equivalent GPIB Commands
{FWD.TRANS.
Make a "thru" connection (that is, connect one port to the
THRU}
other through a cable).
{FWD.MATCH
Make a "thru" connection (that is, connect one port to the
THRU}
other through a cable).
It is necessary to make both of these measurements.
3-24 8510XF Network Analyzer Systems
Advertisement
Table of Contents
