Table of Contents
Advertisement
Duplicate Listings
From 85101C...
IF/display interconnect
8510 interconnect
From 85102B...
IF/display interconnect
Test set interconnect
10 MHz in
Trigger in
Installation
Cable List
Cable List
System cabling for the 8510XF is outlined in the tables below.
In these tables, a complete from/to connection list is given for the network
analyzer, the RF source, the LO source, the controller, the left test head, and
the right test head. In other words, each cable is listed twice, and can be
found by looking up the connection from either end. The duplicate listings
make it easier to check the cabling after installation, if a cabling error is
suspected.
In the Notes column, the phrase "duplicate listing" means that the cable has
already been listed once before. The phrase "factory installed" means that
the cable was installed prior to shipment (generally, cables between rack
instruments are factory installed; cables between the millimeter-wave
controller and the test heads are not).
Table 2-7
Cable List (Connections from the 8510C)
To:
85102B -- IF/display interconnect
Millimeter-wave controller --
8510 system bus
85101C -- IF/display interconnect
Millimeter-wave controller -- test set
Interconnect
83651B -- 10 MHz RF output
83651B -- trigger output
2-32 8510XF Network Analyzer Systems
Notes
Cable Type
factory installed
Multi-pin
factory installed
GPIB
factory installed;
Multi-pin
duplicate listing
factory installed
Multi-pin
factory installed
BNC
factory installed
BNC
Part No.
08510- 60101
8120-3447
(Model 10833C)
08510-60101
08510-60107
8120-5370
8120-5370
Advertisement
Table of Contents
