Omron E5 D Series Communications Manual page 26

1 Communications Methods
1-1-7 Communications Parameter Setup
Before you carry out communications with the E5@D, set up the communications unit number, baud
rate, and other parameters by carrying out the following procedure. For details on operations other than
communications parameter setup, refer to the E5
(Cat. No. H224) for the devices being used.
(1) Press the O Key for at least three seconds to move from the "operation level" to the
"initial setting level."
(2) Press the O Key for less than one second to move from the "initial setting level" to
the "communications setting level."
(3) Select the parameters as shown below by pressing the M Key.
(4) Use the D or U Keys to change the parameter set values.
psel
cwf
M
u-no
M
bps
9.6
M
len
M
sbit
M
prty
even
M
sdwt
M
ramm
bkup
M
*1 Displayed only when the Protocol Setting parameter is set to CompoWay/F.
*2 Displayed when the Protocol Setting parameter is set to CompoWay/F or Modbus.
1 - 6
Protocol Setting
Communications Unit
No.
1
Communications
Baud Rate
Communications Data
Length *1
7
Communications Stop
Bits
*1
2
Communications
Parity *2
Send Data Wait Time
20
Write Mode
@
D Digital Temperature Controllers User's Manual
E5@D Digital Temperature Controllers Communications Manual (H225)