Advertisement
Changing E5CD Settings
(1) Initialize the download areas with the set values from the E5CD Controllers.
The download areas have not been initialized, so we will initialize them with the set values
from the E5CD Controllers.
Enter 2 (download area initialization) as the value of D015 (Request Flag) in the Watch Tab
Page and press the Enter Key. D015 to D029 is the download area for the No. 0 Controller
(E5CD), D045 to D059 is the download area for the No. 1 Controller, and D075 to D089 is
the download area for the No. 2 Controller.
The following parameters are displayed in the download area for the default settings.
No.0
D015
D016
D017
D018
D019
D020
D021
D022
D023
D024
D025
D026
D027
D028
D029
(2) Confirm that the download areas have been initialized.
When initialization is completed, D000 (Response Flag) will change to 1 (Normal End) and
D015 (Request Flag) will automatically change to 1 (Enable Writing). Check the download
areas to see if they have been initialized to the values given in the above table.
E5@D Digital Temperature Controllers Communications Manual (H225)
No.1
No.2
D045
D075
Request Flag (fixed)
D046
D076
Operation Command Code
(fixed)
D047
D077
Set Point
D048
D078
Proportional Band
D049
D079
Integral Time
D050
D080
Derivative Time
D051
D081
Alarm Value 1
D052
D082
Alarm Value Upper Limit 1
D053
D083
Alarm Value Lower Limit 1
D054
D084
Alarm Value 2
D055
D085
Alarm Value Upper Limit 2
D056
D086
Alarm Value Lower Limit 2
D057
D087
Heater Burnout Detection 1
D058
D088
PV Input Shift
D059
D089
SP Ramp Set Value
6 Programless Communications
Parameter
1 (0001 hex)
0 (0000 hex)
0 (0000 hex)
80 (0050 hex)
233 (00E9 hex)
40 (0028 hex)
0 (0000 hex)
0 (0000 hex)
0 (0000 hex)
0 (0000 hex)
0 (0000 hex)
0 (0000H hex)
0 (0000 hex)
0 (0000 hex)
0 (0000 hex)
No.1 (D015 to D029)
No.2 (D045 to D059)
No.3 (D075 to D089)
Value
6
6 - 47
Advertisement
