Advertisement
6 Programless Communications
With the default settings, the following parameters are set for the upload areas.
Check the values in the upload areas to see if they are the same as those that are given in
the following table. (It is not necessary to check addresses for which "---" is given in the
Value column.)
No.0
D0000
D0030
D0001
D0031
D0002
D0032
D0003
D0033
D0004
D0034
D0005
D0035
D0006
D0036
D0007
D0037
D0008
D0038
D0009
D0039
D0010
D0040
D0011
D0041
· · ·
· · ·
D0014
D0044
*
If the default settings are used and a sensor is not connected, the PV display on the E5CD will show an input
error (s.err) and the process value in the upload area will be 1320 (528 hex).
Changing E5CD Settings
(1) We will check the area that is used to change E5CD set values.
The area that is used to change the set value is called the download area.
D0015 to D0029 is the download area for the No. 0 Controller, D0045 to D0059 is the
download area for the No. 1 Controller, and D0075 to D0089 is the download area for the
No. 2 Controller.
6 - 30
No.1
No.2
D0060
Response Flag (fixed)
D0061
Communications Status (fixed)
D0062
Communications Monitor
D0063
Status 1 (Upper Word)
D0064
Status 1 (Lower Word)
D0065
Status 2 (Upper Word)
D0066
Decimal Point Monitor
D0067
Process Value
D0068
Internal Set Point
D0069
Heater Current 1 Value Monitor
D0070
MV Monitor (Heating)
D0071
Nothing assigned.
· · ·
· · ·
D0074
Nothing assigned.
Parameter
0
Alternates between 0 and 1.
---
---
---
---
---
Process Value *
---
---
---
---
· · ·
---
E5@D Digital Temperature Controllers Communications Manual (H225)
Value
No.0
No.1
No.2
Advertisement
