Omron E5 D Series Communications Manual page 161

Click the Yes Button in the transfer confirmation dialog box to transfer the settings.
To restart the Unit and enable the transferred settings, click the Yes Button in the restart
confirmation dialog box.
In the Port Selection Dialog Box, select All ports and click the OK Button.
Click the OK Button in the dialog box that says the transfer was successfully completed.
This completes setting up the PLC.
You will use the Sysmac Studio to check operation, so leave it online.
6-7-4 E5@D Controller Setup
Set up programless communications. Perform the procedure that is given in 6-4-4 E5
Setup.
6-7-5 Checking Operation
Perform the checking operation given in 6-6-5 Checking Operation.
E5@D Digital Temperature Controllers Communications Manual (H225)
6 Programless Communications
@
D Controller
6
6 - 53