Advertisement
6-11 Connecting to Keyence KV-series
PLCs
6-11-1 Configuration and Procedure
The following configuration is used as an example in giving the setup and application procedures for
programless communications.
• All of the E5CD Controllers must be the same model. (Copying parameter settings is not possible if
the models are different.)
• DM0 to DM89 are used in the PLC memory. The default E5CD parameter allocations are used.
• A commercially available USB2.0, A/B cable is used.
Commercially
available USB
cable
IBM PC/AT or compatible
KV STUDIO
Programming
Software
Note: Refer to the KV STUDIO User's Manual for the installation procedures for the KV STUDIO and USB driver.
The application procedure is given below.
START
Wire the network.
Set up the PLC.
Set up the E5@D Controllers.
Check operation.
END
E5@D Digital Temperature Controllers Communications Manual (H225)
Turn ON the terminating resistance switch.
KV- 700
KV-L21V
USB port
Wire the KV-L21V to the E5CD Controllers.
Use KV STUDIO to set up communications on the KV-L21V to enable
communicating with the E5CD Controllers.
Set up programless communications in the E5CD Controllers.
Use the KV STUDIO to confirm that programless communications are operating.
6 Programless Communications
E5CD
E5CD
No.0
No.1
RS-485
E5CD
No.2
6
6 - 87
Advertisement
