Advertisement
With the default settings, the following parameters are set for the upload areas.
Check the values in the upload areas to see if they are the same as those that are given in
the following table. (It is not necessary to check address for which "---" is given in the Value
column.)
No.0
No.1
D0
D30
D01
D31
D02
D32
D03
D33
D04
D34
D05
D35
D06
D36
D07
D37
D08
D38
D09
D39
D10
D40
D11
D41
· · ·
· · ·
D14
D44
*1
If the default settings are used and a sensor is not connected, the PV display on the E5CD will show an input
error (s.err) and the process value in the upload area will be 1320 (528 hex).
*2
This area cannot be used for a Mitsubishi FX-series PLC.
Changing E5CD Settings
(1) We will check the area that is used to change E5CD set values.
The area that is used to change the set value is called the download area.
D15 to D29 is the download area for the No. 0 Controller (E5CD), D45 to D59 is the
download area for the No. 1 Controller, and D75 to D89 is the download area for the No. 2
Controller.
E5@D Digital Temperature Controllers Communications Manual (H225)
No.2
Parameter
D60
Response Flag (fixed)
D61
Communications Status (fixed)
D62
Communications Monitor
Parameter
D63
Status 1 (Upper Word)
D64
Status 1 (Lower Word)
D65
Status 2 (Upper Word)
D66
Decimal Point Monitor
D67
Process Value
D68
Internal Set Point
D69
Heater Current 1 Value Monitor
D70
MV Monitor (Heating)
D71
Not used.
· · ·
· · ·
D74
*2
Not used.
6 Programless Communications
Value
0
Alternates between 0 and 1.
---
---
---
---
---
*1
Process Value
---
---
---
---
· · ·
---
No.0
No.1
No.2
6
6 - 63
Advertisement
