Table of Contents
Advertisement
Procedure
To create a bootable USD flash drive, proceed as follows:
1. Connect the USB flash drive to a USB interface of the PC system.
2. Start Symantec Ghost, for example, by entering Ghost32.exe in the search bar in the start
menu.
or
For IPCxxxE (EFI boot), start Ghost via link D:\Eboot\Ghost for Eboot Stick.lnk.
3. In Symantec Ghost, select the "From Image" command from the "Local > Disk" menu.
4. Select D:\Eboot\eboot.gho as the source and the USB flash drive as the destination.
Result
The Emergency Boot System is installed on the USB flash drive and the data storage medium
is renamed to "EBOOT". The Service Center on the bootable USB flash drive can now be used.
10.5.12
Operating a service PC/PC in the network
10.5.12.1
Overview
System network
In the following applications, you will need, for example, a connection between the PC system
and a PG/PC in the system network:
● Save the disk image of the SSD to a PG/PC
● Restore the SSD of a PC system via the DVD drive of a PG/PC
● Start up the replacement SSD
● Install the software on the PC system via the DVD drive of a PG/PC
Company network
If you want to connect the service PG/PC via a company network (Local Area Connection 2;
interface X1), contact your network service center.
Further information on the Windows Firewall settings in the company network can be found in
the Chapter Adapting the firewall settings (Page 202).
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Installing and setting up PCU Base for IPC
10.5 Backing up and restoring data
261
Advertisement
Table of Contents
