Table of Contents
Advertisement
Installing and setting up PCU Base for IPC
10.4 Installing and configuring updates and automation software
pcuhwsvc.ini (Vorlage im Verzeichnis ...\siemens\System\etc)
SeqActive_12= 1
SeqActive_13= 1
SeqActive_14= 1
SeqActive_15= 1
SeqActive_16= 1
SeqActive_17= 1
SeqActive_18= 1
SeqActive_19= 1
SeqActive_20= 1
# Autorepeat-Suppression of Function Keys F1-F12 and Hardkeys
#===============================================
AutorepeatSuppression = 0
10.4.5
PCU Installer
10.4.5.1
Overview
The PCU Installer assists you with the installation of setup packages on PC systems:
● The PCU Installer checks definable setup directories on the PC system, on removable data
storage media, or in the network.
These setup directories must not be write-protected.
● If setup packages exist, they are automatically installed one after the other. The order in
which these packages are installed can be parameterized (Page 236).
● On the top right of the screen, a status display is displayed while the PCU Installer carries
out such activities.
For further information on the activities of the PCU Installer, see Chapter Procedure example
of an installation with the PCU Installer (Page 241).
Overview of the configuration and operation
● When PCU Base for IPC is delivered the PCU Installer is deactivated. You can activate the
PCU Installer during the unsupervised installation of PCU Base for IPC via the response file
or activate it manually after the supervised installation (Page 233).
● After you have made all of the settings for the PCU Installer, using program application
Configure for CMC you can also activate or deactivate the PCU Installer (Page 243).
● You can make all settings in the PCU Installer in the associated configuration file
(Page 236).
232
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Advertisement
Table of Contents
