Table of Contents
Advertisement
10.5
Backing up and restoring data
10.5.1
Overview
You can perform installation and commissioning work on the PC system in the Service Center,
which is based on Microsoft Windows PE.
When the Desktop is active, configuration of the Service Center is possible via the
"ServiceCenter Backup-Restore" (Page 199) icon.
Most of the functions of the Service Center are available in the main menu (Page 246).
In particular, you can create or restore disk images in the Service Center. The following options
are available:
● Create a disk image of the SSD (Page 250)
● Restore a disk image of the SSD (Page 253)
● Create a disk image of a partition (Page 255)
● Restore a disk image of a partition (Page 257)
Further information
The Service Center uses the Symantec Ghost (Page 260) software, which you can also call
separately.
10.5.2
Starting the Service Center
To start the Service Center, proceed in one of the following ways:
● To call up the Service Center on the SSD while the PC system is running up, select the
"Booting Service System" during run-up in the Windows boot menu.
● To call up the emergency boot system on a USB flash drive while the PC system is running
up, set the service switch to E or press F12 or Esc while running up to show the boot
selection.
● To switch to the Service Center while the Service Desktop (Windows 10) is active, click the
"ServiceCenter Backup-Restore" icon on the Desktop and then click "Start ServiceSystem".
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Installing and setting up PCU Base for IPC
10.5 Backing up and restoring data
245
Advertisement
Table of Contents
