Installing and setting up PCU Base for IPC
10.5 Backing up and restoring data
Figure 10-10
Table 10-18 Routing settings in the "Network Settings" dialog box
Setting
Purpose
Add Route
Add a new route.
Remove Route
Delete a selected route.
Destination
Specify the network destination of the route as an IP address.
Mask
Subnet mask of the specified IP addresses.
Next
Next hop or forwarding IP address via which the network destination can be accessed.
Interface
Select an interface to which the configured IP routing applies:
●
Enterprise network interface X1 (Local Area Connection 2)
●
Plant network interface X2 (Local Area Connection)
Metric
Integer cost metric (1 to 9999). Required if several routes for sending a packet to a network destination are possible in the
routing table.
10.5.5
Create a disk image of the SSD
You can create a disk image of the entire SSD in the Service Center with the "Disk Backup"
function.
250
Service Center - IP routing
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB