Network Settings In The Service Center - Siemens SINUMERIK MC Commissioning Manual

Installing and setting up PCU Base for IPC
10.5 Backing up and restoring data
3. Make the required settings here:
4. To start the restore process and entirely replace the existing data on the partition with the
disk image, confirm the settings with "Restore".
Result
The restore process is started.
Note
Troubleshooting if reading in of the disk image fails
If data transfer is interrupted during the restore process, the PC system will have no executable
system.
In this case, use a bootable USB flash drive with Service Center to read the disk image in again.
10.5.9

Network settings in the Service Center

To manage a disk image in the network, you can display a shared network directory on the PC
system as a drive.
In the Service Center, you configure network drives in the "Connect a share" dialog box. You
can call this dialog box directly from the relevant dialog boxes to both create (Page 250) and
restore (Page 253) disk images.
Precondition
The network directory is shared with the relevant user accounts in the domain and on the PC
system.
Further information: Release directory of the PC/PC in the network (Page 267)
258
Section Setting
Base parame‐ Source file
ters
Destination par‐
tition
Base parame‐ Connect share
ters > Destina‐
tion partition
Select source
Purpose
Select the disk image from which the partition is to be restored.
You can use local disk images or disk images stored in the net‐
work.
Select the partition to be restored from the disk image.
Open the "Connect a Share" dialog box (Page 258).
You can manage a shared resource (e.g. a directory in the net‐
work), to use a disk image stored on the network to restore the
SSD.
Open the "Select source file" dialog box.
You can navigate through a local directory on the PC system
and select a disk image for restoration.
Commissioning Manual, 02/2020, A5E47437618B AB
MCU commissioning: NC, PLC, Drive