Table of Contents
Advertisement
PLC commissioning
5.3 Configuring the PLC
Procedure
Proceed as follows to load the configured hardware configuration to the PC system:
1. In the project tree, right-click the device name, e.g. "PC system_1", and select the
"Hardware configuration" command in the "Download to device" shortcut menu.
The "Extended download" dialog opens.
2. Make the following settings in the "Extended download" dialog:
– PG/PC interface: Network card used, e.g. "Intel[R] Ethernet Connection I217-V"
3. Click on "Start search" and then select the found IPC from "Compatible nodes in the target
subnet". Alternatively, you can specify an IP address directly in the "Compatible nodes in the
target subnet" list in the "Address" column.
62
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Advertisement
Table of Contents
