Dodge ZB 2005 Service Manual page 688

ZB
ENGINE MOUNTS (Continued)
Fig. 24 Engine Mount to Frame Nuts (Left Side Shown - Right Side Typical)
1 - ENGINE MOUNT STUD
(3) Install engine mount to frame nut (Fig. 24).
Tighten nut to 102 N·m (75 ft. lbs.).
(4) Remove jack.
(5) Lower vehicle.
INTAKE MANIFOLD
REMOVAL
NOTE: Care must be taken to protect the intake
manifold powder coating from scrapes and abra-
sions.
2 - NUT
(1) Perform the fuel system pressure release proce-
dure, before attempting any repairs. (Refer to 14
- FUEL SYSTEM/FUEL DELIVERY - STANDARD
PROCEDURE - FUEL
RELEASE PROCEDURE).
(2) Open trunk lid. Remove battery cover. Discon-
nect negative battery cable.
(3) Disconnect throttle body air inlet hose, IAT
sensor, and remove air cleaner housing assembly
(Refer to 9 - ENGINE/AIR INTAKE SYSTEM -
REMOVAL).
ENGINE 9 - 27
SYSTEM PRESSURE