ETC PENKO SGM800 Manual page 87

MANUAL SGM800
The following screen is visible:
Use key 1 and key 2 to enter the location latitude of the loadcell(s). Key 1 is used for
changing the number (1-9), key 2 is used for changing the position of the cursor. And
press key 3 >2 sec.to set the location latitude. Choose value between –90,00 and 90,00°
Up
The following screen is visible:
In gcL 4 you can set the location elevation of the loadcell. This is the geographic
elevation of where the loadcell is going to be used. Press key 2 <2 sec. to set the
location elevation.
The following screen is visible:
Use key 1 and key 2 to enter the location elevation of the loadcell(s). Key 1 is used for
changing the number (1-9), key 2 is used for changing the position of the cursor. And
press key 3 >2 sec.to set the location latitude. Choose value between –1000 and 30000
.
meter
Up
The following screen is visible:
Down Left
Down Left
Right Confirm
Right Confirm
87