ETC PENKO SGM800 Manual page 75

MANUAL SGM800
In PcL 3 you can set the Input offset. Choose between choose a sample value between
–50000 and 50000. Press key 2 <2 sec. to change the input offset
The following screen is visible:
Use key 1 and 2 to change the value. Key 1 is for changing the number (1-9), key
2 is for changing the position of the cursor. Confirm by pressing key 3 for >2 sec.
Up
The following screen is visible:
In PcL you can Recall the Pcl parameters.The PcL parameters will be reset to its factory
settings. Press key 2 <2 sec. to recall to factory settings
The following screen is visible:
The following screen is visible:
To recall the factory settings press key 3 >2 sec. To cancel press key 3 <2 sec.
Cancel
The following screen is visible:
Down Left
Recall
Right Confirm
75