ETC PENKO SGM800 Manual page 50

MANUAL SGM800
In Pb 2 you set the profibus Value mode. The profibus value can be shown as Integer
(direct value without decimal point) or as Floating Point (real value with decimal
point). Press key 2 <2 sec. to change the mode.
The options are:
Pb2 FL Floating point
Pb2 In Integer
Select the option you want to use by pressing key 1 and confirm by pressing key 3
>2 sec.
Increase Decrease Confirm The
following screen will be visible:
Note: after a recall or a firmware update, the Profibus needs to be reset. This is done
by power down the device and power it up again.
50