Table of Contents
Advertisement
MANUAL SGM800
1.8
PI Mach II software
The SGM can also be configured for first use by using PI mach II software.
Download Penko Suite from the PENKO website (http://www.penko.com/db/
downloads/) and install Penko Suite. The following items will be installed:
*Pi Mach II
*Job Manager XE
*Drivers
*Manuals
After installing, connect the SGM800 to
the computer using an A-B USB cable.
Start Pi Mach II.
The SGM800 will be found and connected. This is shown in the status bar (lower left
corner).
If there appears a USB error, connect the device manually:
Go to Environment - Communication
Program Interface to configure all Penko devices
Version Control System for Pi Mach II projects
USB drivers for latest series Penko devices
Product manuals and protocol descriptions
23
Advertisement
Table of Contents
