Table of Contents
Advertisement
IMPORTANT SAFETY INFORMATION
READ THIS PAGE FIRST!
Penko Engineering manufactures and tests
its products to meet all applicable national
and international standards. It is vital that
this instrument is correctly installed, used,
and maintained to ensure it continues to
operate to its optimum specification.
The following instructions must be adhered
to and incorporated into your safety
program
when
maintaining Penko products. Failure to
follow the recommended instructions can
affect the system's safety and may increase
the risk of serious personal injury, property
damage, damage to this instrument and
may invalidate the product's warranty.
• Read the instructions fully prior to
installing,
operating,
product. If this Instruction Manual is not the
correct manual for the Penko product you
are using, call 0031(0)318-525630 for a
replacement copy. Keep this Instruction
Manual in a safe place for future reference.
• If you do not fully understand these
instructions,
contact
representative for clarification.
• Pay careful attention to all warnings,
cautions, and instructions marked on and
supplied with the product.
installing,
using,
or
servicing
your
• Inform and educate your personnel about
the correct installation, operation, and
maintenance procedures for this product.
• Install your equipment as specified in the
installation instructions of the appropriate
Instruction Manual and as per applicable
local and national codes. Connect all
products to the proper electrical sources.
and
• To ensure correct performance, use quali-
fied personnel to install, operate, update,
program, and maintain the product.
• When replacement parts are required,
ensure that qualified technicians use repla-
cement parts specified by Penko. Unauthori-
zed components and procedures can affect
the product's performance and may affect
the
the continued safe operation of your
processes. The use of non-specified 'look-
alike' substitution parts may result in the
risk of fire, electrical hazards, or improper
operation.
• Ensure that all equipment doors are closed
and protective covers are in place, except
Penko
when maintenance is being performed by
qualified persons, to prevent electrical shock
and personal injury.
Advertisement
Table of Contents
