ETC PENKO SGM800 Manual page 72

MANUAL SGM800
The following screen is visible:
In dSF 2 you can set the Cutoff frequency. Determines the range used for filtering
the signal. Choose between oFF, 1.0Hz, 1.4Hz, 2.5Hz, 5.0Hz, 10.0Hz, 20.0Hz and
40Hz. Press key 2 <2 sec. to change the cutoff frequency range.
The following screen is visible:
Use key 1 change the cutoff frequency. Confirm by pressing key 3 for >2 sec.
Up Down Confirm
The following screen is visible:
In dSF 3 you can set the moving average cutoff frequency. Choose a value bet- ween 0-320
Hz. Press key 2 <2 sec. to change the cutoff frequency range.
The following screen is visible:
72