ETC PENKO SGM800 Manual page 43

MANUAL SGM800
2.1.5 Menu -Eth-
Ethernet settings (SGM820 only)
Protocols that can be used are Ethernet IP, Omron Fins and Modbus TCP.
For protocol description please download PENKO Suite from www.penko.com
In this menu, the communication settings can be set for the ethernet port.
Options are:
Adr 1
Adr 2
Adr 3
Adr 4
Sub 1
Sub 2
Sub 3
Sub 4
gAt 1
gAt 2
gAt 3
gAt 4
Press key 2 <2 sec to enter the ethernet settings.
The following screen is visible:
In Adr 1 you set the first three numbers of the IP address you want to give the SGM820
(example: 192.168.151.112). Use key 1 and key 2 to change the number Key 1 is for
changing the number (1-9), key 2 is for changing the position of the cursor. Confirm by
pressing key 3 >2 sec.
First three numbers of the IP address
Second three numbers of the IP address
Third three numbers of the IP address
Fourth three numbers of the IP address
First three numbers of the Subnet address
Second three numbers of the Subnet address
Third three numbers of the Subnet address
Fourth three numbers of the Subnet address
First three numbers of the Gateway address
Second three numbers of the Gateway address
Third three numbers of the Gateway address
Fourth three numbers of the Gateway address
43