ETC PENKO SGM800 Manual page 84

MANUAL SGM800
Use key 1 and key 2 to enter the sensitivity of loadcell 3. Key 1 is used for
changing the number (1-9), key 2 is used for changing the position of the
cursor. Sensitivity has to be filled in as 0.00000 mV/V. Press key 3 >2 sec. to set
the sensitivity of the loadcell.
Up
The following screen is visible:
In tcL 5 you can set the loadcell sensitivity for loadcell 4. This information can be found on
the datasheet delivered with the loadcell. Press key 2 <2 sec. to set the loadcell
sensitivity.
The following screen is visible:
Use key 1 and key 2 to enter the sensitivity of loadcell 4. Key 1 is used for
changing the number (1-9), key 2 is used for changing the position of the
cursor. Sensitivity has to be filled in as 0.00000 mV/V. Press key 3 >2 sec. to set the
sensitivity of the loadcell.
Up
The following screen is visible:
When using a theoretical calibration, note that the 2mV/V and 3mV/V range are
calibrated ranges.
Down Left
Down Left
Right Confirm
Right Confirm
84