ETC PENKO SGM800 Manual page 32

MANUAL SGM800
When done with changing the setpoints press key 3 <2 sec to go back to the
main weigher display
TAC code (Traceable Access Code).
The SGM800 has a TAC code inside. TAC code is number of times the indicator data is
changed. When an indicator gets certified this number will be written on the device
and is used by the controlling agency to see if the settings aren't changed after sealing.
To check out the TAC code Press key 3 <2 sec. to go into the Main menu.
Press key 1 <2sec. to the dtAC menu and press key 2 <2sec. to enter.
The following screen will show the actual TAC code.
Press Key 3 <2 sec. to go back to the main menu.
Press key 3 <2 sec. to go back to the main weigher display.
32