Main Menu - ETC PENKO SGM800 Manual

MANUAL SGM800

2 Main Menu

In the Main menu you can change the Setpoints (this option is not available in the
SGM810 or controllers), display the TAC code and display the CAL code.
Setpoints. (this option is not available in the SGM810)
The SGM800 has four outputs that can swithch on/off on different levels.
These levels have to be filled in at the setpoint menu.
Press key 3 <2 sec. to go into the Main menu.
Press key 2 <2sec. to the setpoint change menu.
Press key 1 <2 sec. to select a different setpoint (1-4). Press key 2 <2 sec. to change the
selected setpoint. Key 1 is used for changing the number (1-9), key 2 is used for
changing the position of the cursor. Press key 3 >2sec. to confirm.
Up
When the selected setpoint is changed, the display changes to the next setpoint.
Down Left Right Confirm
31