ETC PENKO SGM800 Manual page 73

MANUAL SGM800
2.1.13 Menu -PCL-
Use key 1 and 2 to change the value. Key 1 is for changing the number (1-9), key
2 is for changing the position of the cursor. Confirm by pressing key 3 for >2 sec.
Up
The following screen is visible:
PCL Pre-calibration settings
In this menu, the Pre-calibration settings can be set. Options are:
Pcl 1
PcL 2
PcL 3
PcL 4
Press key 2 <2 sec to enter the pre-calibration settings.
The following screen is visible:
Down Left
Polarity of input range
Amplifier sensitivity
Input offset
Recall pre-calibration
Right Confirm
73