ETC PENKO SGM800 Manual page 76

MANUAL SGM800
2.1.14 Menu -CAL-
5.2 - - - CAL
In this menu, the Calibration settings can be set. Options are:
CAL 1
CAL 2
CAL 3
CAL 4
CAL 5
Press key 2 <2 sec to enter the calibration settings.
The following screen is visible:
In CAL 1 you can set the calibration points for the weigher. Press key 2 <2 sec. to set the
calibration points.
After entering, the following screen is visible (if there are no calibration points
available):
And will automatically jump to:
Calibration settings
Add calibration point
Check weigher information
Show/remove calibration points
Deadload compensation
Show CAL code
76