ETC PENKO SGM800 Manual page 74

MANUAL SGM800
In PcL 1 you can set the polaritiy of the input range. Un=Unipolar mode the input range
for load cells is –0.2 mV/V to + value set at Range. Bi=Bipolar mode the input range for
load cells is –value set at Range to + value set at Range.Press key 2 <2 sec. To change
the polaritity og the input range.
The following screen is visible:
Use key 1 change the polarity. Confirm by pressing key 3 for >2 sec.
Up
The following screen is visible:
In PcL 2 you can set the Amplifier sensitivity. Choose between 1.0mV/V, 1.5mV/ V,
2.0mV/V, 2.5mV/V and 3.0mV/V. Press key 2 <2 sec. to change the amplifier sensitivity.
The following screen is visible:
Use key 1 change the sensitivity. Confirm by pressing key 3 for >2 sec.
Up
The following screen is visible:
Down Confirm
Down Confirm
74