ETC PENKO SGM800 Manual page 79

MANUAL SGM800
When a number is shown, the deletion of one calibration point is completed and more
points need to be deleted. Press key 3 >3 sec to do so.
>3 sec.
When all calibration points are deleted, the following screen is visible:
In CAL 4 you can set a Deadload compensation. In this menu, the deadload can be set to
pull the whole weighing line back to zero. The zero point could be differ- and because of
some modification on the scale or dirt. Press key 2 <2 sec. to set a new deadload
compensation.
The following screen is visible:
Use key 1 and key 2 to enter the weight that is in/on the weigher. Key 1 is used for
changing the number (1-9), key 2 is used for changing the position of the cursor. And
press key 3 >2 sec.to set the new deadload.
Up Down Left Right Confirm
79