ETC PENKO SGM800 Manual page 33

MANUAL SGM800
CAL code (Calibration counter).
The SGM800 has a CAL code inside. CAL code is the number of times the calibration is
changed. When an indicator gets certified this number will be written on the device and
is used by the controlling agency to see if the settings aren't changed after sealing.
To check out the CAL code Press key 3 <2 sec. to go into the Main menu.
Press key 1 <2sec. 2x to the dCAL menu and press key 2 <2sec. to enter.
The following screen will show the actual CAL code.
Press Key 3 <2 sec. to go back to the main menu.
Press key 3 <2 sec. to go back to the main weigher display.
33